Final Circuit Q Guide

Q-Technology Circuit User Guide with Q-Tape

 

Welcome to the Q-Technology circuit placement guide with our Q-Tape. Follow these steps for correct and optimized application, tailored to your body's needs.

 

 Materials needed

✅ Q -Technology circuits
✅ Q -Tape (adhesive tape specific to our brand )
✅ dry skin

 

 General reminder about the logo's reading direction

📍 Logo always visible and oriented for easy reading:

  • When the circuit is stuck directly onto your own body , the logo should be legible to you (natural reading direction).
  • If you stick the circuit on your own sacrum or lower lumbar region (posterior area difficult to see), orient the logo so that it is readable for someone else who would put it in your place.

 

 Placement areas and reading direction

🔹 Under the arch of the foot (directly on the skin)

  • Place the circuit under each foot , between the interlines of Lisfranc and Chopart.
  • The logo must be legible and oriented in the normal reading direction , face against the arch of the foot (therefore invisible once placed).

 

 

🔹 In a pair of shoes (without direct contact with the skin)

  • Customers who wish to place the circuits inside their shoes should use the same positioning and reading direction as for the arch of the foot:
    ✅ Circuit under the foot, logo legible and oriented in the normal reading direction.

 

 

🔹 On the back of the foot

  • Stick the circuit onto the top of the foot, in the center of the dorsal area.
  • The logo must be legible and oriented for you (normal reading direction when you look at your foot).

 

 

🔹 At the level of the sacrum or lower lumbar region

  • Stick the circuit onto the desired area on the lower back.
  • The logo must be legible to another person who would stick the circuit in your place (normal reading direction for a third party behind you).

 

 

🔹 At the level of the skull, in a cap

  • Glue the circuit inside the cap, under the fabric protective strip, at a level fairly close to the paddle.
  • The logo must be legible from the inside .
  • Warning: this area does not provide such predictable benefits for everyone and may cause dizziness in some people.

 

 

Q-Tape application instructions

1️⃣ Cleanse the skin to remove any traces of cream or moisture.
2️⃣ off the Q-Tape , being careful not to touch the adhesive area.
3️⃣ Position the circuit to the instructions above for the chosen area.
4️⃣ Firmly stick the Q-Tape over the circuit to hold it in place.
5️⃣ down well to avoid creases or air bubbles.

 

 Important precautions

⚠️ Do not apply Q-Tape to irritated or broken skin.
⚠️ If redness or discomfort occurs, remove the circuit and Q-Tape immediately.
⚠️ Replace the Q-Tape as soon as it loses its adhesive power or becomes soiled.